[g356gear]

I picked up a set of Lemons Big block headers off a forum with 250 miles on them for a pretty good deal. I had blown a hole in my #4 cylinder header pipe and needed to get new headers anyway so the timing was good. They are a 2 1/4" pipe header with individual pipes and a 4" collector. They were ceramic coated and had O2 bungs for FI or fuel injection when it comes time for that. They fit super tight and some of the clearances are within 1/8". I had to trim my motor mounts for clearance on both sides and remove 1 grease fitting off my suspension to get full lock to lock without contact. No biggy but they are that tight.