i just drilled four holes in the floor pan. i used some really thick 2" shim washers we have and some shim stock. only the front two mounts need a 3/4 inch shim cut. then i used the washers top and bottom to pinch the floorpan. i was going to build some nice brackets because i planned on bedlining the floor while i had the carpet out. well turns out the floor pans were flawless. no rust or anything so i just rolled the carpet back far enough to work. i really like the fact that that butt of the seat is adjustable up and down. the offer far superior support than the factory seats too.
__________________
'69 Camaro- Daily Driver
'70 Chevelle- Project
|