Quote:
Originally Posted by JRouche
And before using acid wash make sure the epoxy primer manufacture is ok with this. Some are not. I dont think its needed with the epoxies out now. JR
|
You are correct. In checking around, SPI wants NO acid/metal treatment at all applied to the metal before their primer.
I've decided to do some of the sheetmetal before I blast and prime it. I mean, it's obvious that it needs a floor and a few other parts - why not do those now so that I wont be screwing with the epoxy in so many areas. I figure if I epoxy now, I'll be replacing 15-20% of the metal that got primed - and I'll just have to prime that again
