Quote:
Originally Posted by scherp69
So as the title says, I have a question about getting the cotter pin through the ball joint. I'm have Moog 5108 ball joints and I have the nut tight, but it hasn't gone far enough to allow the cotter pin to go through. In the past if I've gone too tight, then the entire shaft starts turning and then I can't tighten it up at all so I ended up replacing them. At $38 each, I don't want to keep replacing them. I can get the cotter pin through one side, but it won't come out the other. Any advice?? Thanks in advance.
|
I had the same issue with my ball joints. The hole was not perfectly centered in my Howe ball joints. I had to sneak up on it to where one side of the hole was opening as the other side was closing my pin would just barley slide in. If I lined up one hole in the center the other side would be closed up too far. It also helped to arc the pin just a little.