Progress...and goodies.
Putting the head on using the torque to yield bolts.
These are the adjustable push rods. You can't run the engine with these. They are only used to determine the measurement for the custom push rods. These are non-adjustable rockers - therefore I have to make up the adjustment in the push rod.
These are the magnum roller tips. They will give me a tad more lift, less friction...AND they will fit under the valve cover.
On the inside - I mounted the new Vintage Air Sure fit system, then sought the perfect spot to run the wire harness. This spot drops the harness right over the back of the engine, and clears the goods on the HVAC.
And...the electronics will all be safely tucked away (thanks to the 4' longer harness) in the rear storage compartment.
Spent the rest of the day running the now 2 gauge (big thick puppy) battery cables, grounds, and other time consuming stuff.
Will set the new Painless chassis wire harness in and connect it to the Watson Hot Dot - push button starter.
Waiting on -
Push rods
Headers.