[ohcbird]

1. Weir Hotrods, Lakewood, McCleoud, and I believe Qicktime make a BH that will adapt that, once you make the input shaft change or modification. I'd reccomend buying the shaft so that the heat treat is left intact.

2. You'll also have to adapt your driveshaft to the Viper's 30 spline output shaft, but that's easy.

3. You'll also need the Viper slave, then use the quick-connect from a std LS trans. Pop the roll pin out of the LS slave & put it in the Viper slave.

You might have to do some hammer work to get the shifter through, but that should be the least of your worries.

What other parts are you getting with the deal? What type of speedo are you going to try to run?