It's an interesting build and I like to learn. The reason I was asking is because I couldn't help but notice that in your last post showing pictures - the very first picture in that set shows a board holding two tubes just ahead of the motor - note that it is sitting flat on the table BUT in the last picture of this set - that very same board is off the table a 1/4" or more... And the hub appears to be just sitting on a couple of stacked up 2X4's that don't appear to be secure - nor is there a hub on the passenger side at all... so what keeps you square and true... I don't see any center line or any permanent markings on the table to pull from etc. Personally I've never been able to weld anything and keep it from pulling off line - without it being more than securely clamped. So is your plan to take this off the wood table and transfer it to a chassis table for finish welding?
|