Quote:
Originally Posted by DOOM
Jason I went through your build thread and have a question... Can you tell me what method you use for closing or opening the body gaps.
|
1/8" round bar and welder for closing, grindin and weldin for opening. There alot in of steps and it takes alot of time. I hammer and dolly edges as flat and thin as I can get before adding or removing material. On edges of quarters and such if there soft I will cut and add rod to get a sharp edge. You have to go slow and take your time with lots of hammer and dolly work. I seen some guys make a mess out of panels. Pacual said you can have your gaps out of bondo or metal, you choose.
I had to re-skin both doors and I fully welded the inside so there are no seams
Here is some pics of the doors
