[Garage Dog 65]

Hi all !

Over Christmas and New Years I started thinking about a welding table design that I could build. I searched the web for pics and ideas and found some interesting ideas. Just wondering if anyone here that uses a table often has some additional ideas or preferences they might like to add. Post your pics, ideas and comments !

I'm looking to build a 36 x 36 with a 1/2 thick top. 4 square legs (2 or 2.5) with levelers. Square or round tube cross supports.

C clamp and Vise Grip hangar rail(s) on the left side.

I plan to have a hole grid pattern waterjet'd on the top so I can thread the holes to mount hold-down jigs, tooling and clamps.

I liked the ability to bolt down accessories (vise, grinder, hanger dolly stand, etc) to the table with a standard size mounting plate. Maybe even a shelf under the table to place the accessories out of the way while not used.

Hangers/holders on the right side (I'm correct handed) for the torch to hang and welding pliers, etc.

Electrical main cable with a couple outlets.

Miller even has a 12 x 12 opening in their top that allows installation of a torch/plasma cutoff area and includes replaceable cross bars. There is a removable catch tray under that area to dump the junk.

Basically a smaller table for a garage dog that provides lots of versatility needed in a home hobby shop.

Here's some pics of the nicer one's I've seen.

Jim