01-05-2010, 12:48 PM
|
 |
Lateral-g Supporting Member
|
|
Join Date: Jul 2005
Location: Scottsdale, AriDzona
Posts: 20,741
Thanks: 504
Thanked 1,080 Times in 388 Posts
|
|
This is the welding/work table I made from a 1/2" sheet of steel... I added the "square post" at one end so I could drop some power there - and then later added the "peg board" cantilevered out so I could hang some "stuff" on... it keeps most of the table clear and I haven't run into any interference problems "yet". I use the POST for spools of wire storage and to 'stick' various vise jaw cushions to etc.
I mounted my Beverly shear to one leg ---- and on the other end - mounted my braided steel cutting saw...
|