Thread: Pinion Angle Question
View Single Post
  #21  
Old 01-09-2010, 08:17 PM
MickyT MickyT is offline
Junior Member
  
Join Date: Jun 2005
Posts: 10
Thanks: 0
Thanked 0 Times in 0 Posts
Default Still confused
Im installing a Moser rearend behind a 406 SBC with Turbo 350 with a GV overdrive unit and a shortened drive shaft and have 3.5 down measuring from the starter on the engine which I read is an acceptable place to measure from for trans and the rear is -2 measuring using the vertical pinion yoke. This is on a lowered 67 Camaro. Reading this thread I need to shim rearend 5.5 degrees up to be correct. Is this correct and do I need to be concerned re working angles? Thanks for any assistance
Last edited by MickyT; 01-09-2010 at 08:29 PM.
Reply With Quote