Quote:
Originally Posted by 68protouring454
no, a common issue with goodmark trunks is there too small for the hole width wise. the gaps were arounf 7/16ths. we sliced the quarter 1/16th from edge, moved over till we had 3/16ths strong gap and measured, then used shear to shear filler piece that we but tig welded in using silicon bronze. metal finished to 80 grit and body worked.
goodluck
|
Without a tig welder, should I stay away from silicon bronze? How do you use silicon bronze to seal / fill the joints between the tulip panel / qtrs and qtrs to rear body panel? Can I use a mig? if so size wire?