View Single Post
  #8  
Old 02-06-2010, 06:57 PM
Northeast Rod Run's Avatar
Northeast Rod Run Northeast Rod Run is offline
Senior Member
 
Join Date: Jan 2008
Location: Massachusetts
Posts: 363
Thanks: 0
Thanked 0 Times in 0 Posts
Default

Quote:
Originally Posted by eville View Post
my understanding is that there is a limit set on how far the window rolls up. I have a Fisher manual somewhere. I'll look for that page...
there are adjustable stops at the bottom of the track. you can actually take them off and the windows will go up much too far.

If I remember right (which I'm almost positive that do), besides all the track adjustments, there are also two round discs at the front and rear of the glass that help push the bottom of the window against the seal as they get near the top. these use a special tool to remove. in my car they were different size front to back, so I could interchange them and make the front push in tighter than the back

My Camaro has shaved door handles, so this really becomes a PIA when it needs to be done. I thought I had them "close enough", because with 3" pipes going into 2 chamber Flowmasters that have dumps sitting just behind the front seats, wind noise is never an issue

what became an issue, was at the end last year on the Northeast Rod Run, I went into one of those touchless highpressure car washes. BIG MISTAKE!!!

I must have had over 1" of water on my floors I'm going to have to re-address that in the spring. adjusting windows suck!
__________________
TJ Ragucci

http://www.northeastrodrun.com/

Last edited by Northeast Rod Run; 02-06-2010 at 07:01 PM.
Reply With Quote