We have been hammering away on the Boss Snake.. Here are a few updated pics for you all.. The first is a filler panel we made to go between the lower area of the rad support and the lower valance.. Not only does it look cleaner but it strengthens the fiberglass valance if you clip a yellow cone or two with it..
The second pis is a panel we made to cover the rear floor area.. Under the panel is where the air tanks are mounted for the suspension, Third pic is a panel we made on the inside of the engine bay that flows off of the bottom of the radiator, again just to give the engine compartment a cleaner look. Pics four through seven and pic eight is the work we did to the rear bumper.. The gap between the bumper ends and the taillight panels was a bit to much for our liking.. We cut apart the bumper and added to the ends for a tighter fit. We also sucked the bumper in tighter to the body. Lastly is the dash we are making for the car. In this pic it is in the early stages.. It is undergoing changes as we speak...