Well I guess I will have to show the table my High school intern is building in the afternoons. 37" tall, .5 inch plate with water jet holes for grid pattern. 4' x 16'. My plan is for this to be a production table for chassis designs. We will have fixtures that bolt to the table for different chassis's. This way we can design and cut all the parts, tooling and fixtures for a certain chassis to bolt to this table.
But underneath will be a material storage rack. The long side support rails will be open instead of miter cut corners to store stainless brake and fuel line plumbing inside with out damage.
I have been thinking about this one for weeks. I wish I would have seen this thread sooner. So good ideas in here.
|