Quote:
Originally Posted by Garage Dog 65
Cost was $140 It was 34 x 48 before being cut to final size or 32 by 48, They needed 1 inch on 2 sides for hold down clamps during the waterjet operation. You should be able to find cheaper as scrap - but I looked for a couple weeks and decided to go to my local steel vendor and buy new.
Jim
|
I was looking for scrap as well, but I don't quite know where to look. The steel plate I have found as scrap has been 1/4 inch. How much does the 32x48 plate weigh?
This thread is great for someone thinking about building a welding table. There are a lot great design features to take.