Great point. For some reason I was just picturing a stock axle housing that wasnt being modified. I was stuck on stupid. Happens to me alot, I prolly should re-boot the operating system more often
Wish I had a simple button like my computer. But I still rely on shock treatments to re-boot the brain. Painful man!!! Ok, going to re-boot. Dont smell the smoke, its pretty bad. ZAP!!! JR
Quote:
Originally Posted by ccracin
Frank is right on. Actually this is something everyone should do. If you do alot of welding on the tubes to mount brackets, it is not uncommon to warp a tube. You should check the "toe" as well as "camber". If you do have a problem, I recommend taking it to a rear end shop and they can straighten it in a number of ways. Press, heat and quench or in some extreme cases they may have to cut the ends off the tube and re-weld them in alignment. I have seen this hundreds of times while I was racing. It turns up when trying to do an alignment on the race cars only to find out you can't get everything square. This issue is usually the culprit. I was actually going to start a thread on this some time ago and then forgot. I see alot of people welding brackets to rear ends and then just installing them. I hope they are checking them before they move on. Just my 1.5 cents! You guys are building some sweet machines. Keep up the good work.  |