That is the idea we are using. The rear crossmember behind the bumper is 1.5" tubing we cut that piece to 40.75 and cap both ends and slide the open holes on the end of the chassis onto that piece of tube and weld it flush on the outside and you now have aligned the rear of the chassis and set the width. We also use the lower link mount for the 4 link that is in the chassis. Plus the front crossmember tabs through the inside and out plate of the frame rail.
You guys should build a Tri-5 with one of these chassis's. Tracy was talking about getting one to see what the dream weaver could do in an upholstry shop.
|