Matt,
We did switch to the flush mount valve stems, the problem was with a 6.2 back space the inside spokes of the center hit the W caliper body. So we added a 1/4 spacer to move the wheel away from the caliper. Now that brings the wheel out very close to the inside edge of the fender. Im going to check the camber curve to see if that will tilt the wheel in some.
The rears just need to go in about 3/8 - 1/2 inch. Theres 1-1/4 on the back side. The rear is suppose to be 56 inches built by DSE and my quarter panel lips are full(not trimmed). I really dont want to trim them. Im going to measure everything tonight to make sure it was made correctly. I think the rear wheels are also a 6.2 backspace. They sit almost line to line(rubber to lip edge.
What kind of gap do you have in the back of your car?
Thanks Rich
|