Quote:
Originally Posted by GregWeld
Jim --
Never have had that code.
A couple things come to mind just to toss out there.... make sure your ECM is not near the ignition box... they don't play nice.
Did you ground the block to the chassis etc.
Resistor plugs must be used (as I understand it).
I have that same set of plug wires...
|
All is good with the grounds and the distance between parts is good.
It all worked before the engine change without having this code come up. it is a simple problem doing it or I have an ecu problem now. But when it runs it seems good so the ignition box and coil along with the sparkplug wires and the whole dizzy setup is causing it somehow.
I should have the new rotor by noon and will know if it is the cause, it had to be replaced anyway to make sure it is not the problem and I have learned to do 1 thing at a time to find the culprit.
Thanks