Quote:
Originally Posted by ivmotor
I didn't take a pic of the last one I did. Here's what I do: mill off the 4x teeth from the gear you have now. Cut a .380" slice off some 4" .375" wall tubing. Weld the slice in the right spot with four rosettes. Bake until a toothpick inserted in the middle comes out dry. Takes me a couple hours...
|
Then I do the frosting??? :yum:
Why not just fill the area between the two large peaks and grind off the two small ones?
__________________
"A ship in port is safe, but that's not what ships are built for."
See Bad Penny run the cones:
https://www.youtube.com/watch?v=8GUPPIX-92U
1971 Chevelle Wagon - Roadster Shop Chassis ProCharged Shafiroff LS and lots of yada yada
1968 Camaro - Project Track Rat - 440 RHS LS