Completed the first stage of the boot fit out.
Measured up and cut the main part of the floor in 10mm MDF and the outer sections in some left over particle board used on door trims.
Cut out the recess for the wheel. Measured five times cut once. Then measured up the carpet and carefully cut around the perimeter and then the fuel filler tube. I left a little bit of carpet overhanging the wheel recess for a tight fit. Wheel went in nice and snug.
The Sub box was refitted and the dodgy wiring fixed up to avoid a fire. :raisedeye
That will do for now (nothing like being stooped over for a couple of hours to stuff your back). Next stage will be the side panels and mounting points for a few tools and cleaning gear.