I have the following items for sale in El Segundo, CA:
DSE close out panel-
SOLD
Has been painted silver, does not have the fender braces and was never mounted
ACPT carbon drive shaft- $400
Sale Pending
Came from a late model 4th gen Camaro with a T56. Length, caps and yoke would be the same as a factory 4th gen driveshaft
Tilton dual master with 1st gen mounting plate-
SOLD
Comes with masters, adjusting knob and firewall plate/clevis setup.
Stainless steel/mild steel bends- 20 bins of it-
SOLD
This is all the materials I used to keep on hand to make the ATS Tri-Y headers in stainless and mild steel. This is valued at over $12K and it was all purchased from SPD. Jigs not included
ATS Tri-Y headers, mild steel with black Jet-Hot coating-
Sold
Comes with V band collector clamps, never installed, never ran headers. Fits 1st gen Camaro, 3rd gen Nova
Anvil carbon rear spoiler, 67/8-
SOLD
Came from my black 68 Camaro. Has clear coat chip on back side
2002 Z06 Corvette LS6 wiring harness- $75
Came off engine that was in an accident, battery acid got on some wires and melted them.
1968 Camaro RS vacuum hose, wiring, and misc parts- $300
All RS vacuum hoses, factory type wiring harnesses, new actuators, and parking light assemblies
Summit Racing brake prop/dist block-
SOLD
Combo distribution block and brake bias knob
Champ Pans LSX oil pan-$200
Bare metal, no pick up tube, built to ATS specs
All items are less shipping.
Tyler