Quote:
Originally Posted by 2Bad4Ya
Long story short had someone shoot the camaro and the paint job is wavy/ripples all over the place. I asked the painter how he wet sanded the car because it was straight after we blocked/guide coated the car. He then shows me on a piece of scrap metal. 3m paper and his hand... no block just his finger tips!
Would/could this be the culprit of my new rippled torch red front panels? I have always been told to NEVER block by hand, always use a sanding block etc... hence its called blocking.
I am contiplating whipping out the DA and some 2k mirka and try to smooth out the clear some and rebuff it. Think that will work? The panels were heavy coated with clear. he had puddles of clear on the floor in some spots the size of a quarter and thicker than 2. lol
|
NO DA!!!!!!!!!!!!!!! If you have that much clear on the car start with 800 - 1000-1500 and finish up with at least 2000...
