Ok, this thread is a little old but I thought reviving it would be better than opening a whole new thread (with the same basic theme).
So I have access to a media blast room large enough to do a car shell (good friend of the family). They do metalizing so they are probably not going to have the correct media. He said as long as I buy the media I can use the booth/equipment.
I am thinking Walnut Shells (I had my '89 Trans-Am done with them and all was well) for the sheet metal/paint removal. Then either Startblast or Aluminum Oxide for the rusty areas. Sound right? If so, what grit?
He gets his media from here:
Media. Any Advice?
Thanks in advance!
Chris