[CamaroAJ]

after power washing the house for the past few days i got to finish the engine/trans install.

didn't take any pictures but i cut the speedtech transmission mounts off the frame and then smoothed the old welds. then i installed the engine and trans to where i wanted it to be with the best fit for the rest of the stuff i have to do to the car. then i bolted the transmission cross member to the trans and the mounts to the member and rewelded them to the frame. about 4" back from where they were.

for the engine mounts i bent 1 3/4" .134 cage tube and built two uprights. i still need to finish welding and add two supports to make sure the engine doesn't move fore and aft just in case. i tried aftermarket mount adapters but they were not even close to fitting so i went to lowes and bought some steel plate and made my own.






lower part of my car is the steering rack. thats with the stock camaro oil pan