[tcronkright]

I spent today at All Speed helping the guys on the project. We assembled the Wilwood 14” front rotor set up including the safety wiring. We also modified the spindles to accommodate the Wilwood hardware. We painted the bell housing, spindles, motor mount plate and Ididit adjustable steering column. We also installed the QA1 dual adjustable front coil over suspension system in the front.

I took some shots of the car with all the panels hung and gapped. The guys at All Speed did an amazing job on the fabrication as every panel is tied back to the body, closed out and properly gapped. At the end of the day we sprayed three coats of sealer on the raw metal.

We are going to drop the engine in tomorrow and start on the plumbing. Final body work also starts tomorrow. Let me know what you think of the body mods!