[Tuske427]

Following the small panel install I decided to start chopping the back of the car off for the trunk floor and tail panel replacement. I made some decent progress, imo, as the tail panel is roughly trimmed and could be tacked in place. I think. Before I do that I want to make sure the inner panel fits and everything looks square. I also need some paint for the inner frame rails. I would use some rust encapsulator and tried to order some, but I was just informed as of Aug 1st the Eastwood co. can no longer sell that to residents in CA. @#$$%!!! I'll keep my political comments to myself. I'll have to see what else I can get in its place.

I used some square stock to brace what's left of the car while I chopped the tail off, and I repaired some of the frame rail ends to reinforce them as they were pretty much rusted away.