[Cris@JCG]

I happen to have this C6 Corvette pedal lying around & was looking @ the way the factory did the clutch master cylinder... So we dimensioned out the mounting base & machined a 1/8 plate to match the slip & locking of the master cylinder & made a custom -3 AN fitting for plumbing... nice & compact!!.. and can be replaced with a factory GM Corvette unit..






We finally got around to mounting the firewall plate & finished the transmission tunnel on the firewall..





We almost got the tunnel done on the interior ... We left it open on the rear because we got some Sparco seats on order & want to fit them up to the owner & make an arm rest instead of a console...