Quote:
Originally Posted by exwestracer
Hope this all makes sense.
|
Most of it
Thanks !. Any particular length for the bars, or should I base the length of the lowers on how long I can make the uppers ? I'm not too concearned about retaining bed space, so I can make my frame any way I need to in order to accomodate the suspension.
I'd like to hear more about centering the uppers on the housing as opposed to centering on the frame, which is what I was considering. It's easier to weld to the axle tubes than to the cast center of the Dana. I can always make a bracket for mounting to the center of the diff. If you don't feel like typing and know of a link, that would be great.
The upper and lower link points on the housing will obviouly be seperated vertically. Is there any specific distance I should aim for ? And should that distance be equally divided above and below the axle center line ?