Quote:
Originally Posted by 67ragtp
Im working with an LS7 in a 69 camaro, my drive angle measured at the crank pulley shows the trans down 4 degrees. Does this seem excessive? If I lift the trans Im smashing the tunnel and this is with a tko 600 install. Just curious if 4 degrees is ok for fluid levels and possible vibration issues?
I believe I will have to lift the rear yoke up 3 degrees(dse 4 link)?
Thanks Rich
|
That's just fine for the engine, but I can't comment on driveline angles and such. I don't know how the DSE setup is adjusted.