[exwestracer]

Originally Posted by jake72ss

what would be wrong with building the end of the torque arm like Griggs does
http://www.howardweb.org/fastgt/docs/griggs_arm2.jpg http://www.griggsracing.com/images/MTA1000RST.jpg

it looks like the hole in the crossmember is a bit larger than the sleeve and that allows the torque arm to slide front to rear and side to side.

Would this have any downsides?

If you're planning on limited travel and body roll, nothing wrong with it at all. The bushings even give you the opportunity to "tune" how the arm hits the chassis slightly. Just be careful when jacking the car up, etc. not to over articulate the bushings.