Quote:
Originally Posted by badrs69
Looking good Mario. What did you end up doing for sheet metal?? I just got a new rear body panel from D and R and although it is much better fitting than the last one I used it is still over 3/4 of an inch wider than may org one  |
I did use DnR for pretty much all my sheet metal. But they will never get one penny from me again!!
A little issue that really pissed me off. I'll tell you about it when I see ya. I have to talk to you about this tail pan issue when I get there. What pan did you order from them they offer a couple of diffrent ones???