I recently ordered an AME Tri-4bar for my 68 Camaro, at the same time I picked up my car from the media blaster. so here is my situation
1) I definatly need to replace the floor pan, and possibly toe boards
2) The quarters are questionable, I will probably replace them
3) The truck pan has some rust, but i could patch it without replacing it, but from what it looks like i should probably just replace it
4) I am doing Mini tubs, and Subframe Connectors
5) the taillight panel is pretty smashed, it looks like the car took a hit to the left rear from whats going on inside the trunk
My question is what is the best order to do all this?
i was planning on doing the floor and trunk pan, then quarters and tail, AME, then tubs and connectors...
This is my first time getting this deep into a car(I have faith I can do it right), so I wanted to check with the knowledge of the
