[64pontiac]

Ok, on to the hood....... I know that some may not like it, the customer wanted the fiberglass stinger and I figured he has too much moneygoing into this to have the same hood as everyone else....

So we made the front spear the same as the side vents that we made, and went with a subtle height and we will have some billet vents in behind it. As it is efi, we dont need a scoop really. Also, I hate how most of the cowl hoods and the stinger hood dont have the body lines from the wiper cowl in the hood, only the one peak. So we wanted the hood to roll out of the wiper cowl into a bulge, then back to nothing.

I think it worked well, it looks amazing with the striping on it (save that for later!) Its truly one off... even the bracing underneath we tried to finish off so it looks factory ish. The hood is made of 4 pieces and a stock hood, plus our two vent tunnels that are one piece each.