I've went to SAR today to work out a few more details -- there's always lots of details even on a simple little POS like this!
They're going to cut down the column drop and 1/4 over the edges to make it a bit "neater" - it's too large as is. Easier to whack this one than set up a new one - thus the green tape and cut lines.
The new dash installed for me to "okay":
I asked them to hide the headlight switch and the heater controls under the dash - to keep this nice a simple. Also going to use a beige faced gauge with red pointer ala the Classic Vintage set like shown here:
http://www.classicinstruments.com/se...?SeriesCode=VT
The firewall is repaired and painted as is the the rear valance where the old exhaust had cutouts sculpted in the body.
