[DOOM]

I'm getting ready to weld in my lower firewall. But for three days now I have tried everything to make this thing fit to no avail. The issues are endless. Right now as you can see in my photo bucket pics I have the sub bolted in. it bolted right up no problem. Now keep in mind that all the mounting points are from my old UNDAMAGE locations. Everthing as of now has set right in,upper cowl no problem I also made a jig off the old one before I cut it out. I set the new one in the jig and it welded in perfect. The floor literally fell into place! Then I set the lower firewall/toeboard in and now the issues are extensive. I two main issues the right side rocker is about one inch from the toeboard. The left side right at the area that the firewall meets the upper cowl it out about an inch. Now if I push this back with the portapower I can get it to sit where it needs to but then it pushes the area down where the floor meets the toeboard creating another issue.Then the next problem is the subframe mouting points all change because I'm forcing everthing back. Like I said before the subframe bolted right in.. I have to believe that this lower firewall is just made wrong. Has anyone run into these issues with these aftermarket firewalls??? If anyone has any ideas give me a call its alot easyer to explain whats going on. This is just a general discription of these issue. I'm tring to get some pics up but my camera is giving me fits. 708-751-8432....