Car is looking great. Not to keep bringing the Silicon Brazing up but it just amazes me. From working in body shops in the past, we never used anything like this. I assume that Dan is brazing over the entire gap and just cutting the body line back in with something like a cut off wheel or whatever. Here is an article on silicon bronze filler that I found interesting and informing,
http://metalshapers.org/101/covell/c...ilbronze.shtml. You mentioned that he uses TIG to lay it down but from the article, there are a few options. Any further information that you could share would be great as I would like to try this on my build.
Thanks,