Quote:
Originally Posted by arrowem
Hi, I figured of all the forums I frequent, this is THE place for a supercharging question. I am new to the concept of supercharging MY engine. I was formulating a build and then just when I was about to pull the trigger...BAM, someone came out with an elegant way (kit) to add a supercharger to an old pontiac engine and keep it under the hood...SOLD!!!!
Just an update- It will be a '68 468ci Pontiac block, aluminum heads, carburated. I am planing on a D1SC.
Now my questions.
1) Due to the price of the units themselves, I have been looking on ebay. Is a D1SC that came in a Mustang kit the same as if I bought one off the shelf? I know the brackets and some of the piping would be tossed but I would think I could reuse some parts.
2) Is there a simple diagram of supercharger plumbing? Like where does all that piping go into and out of?
3) If adding an intercooler, are they universal? The guy who builds the kits told me they are a $1800 add on, but I see them on ebay for $100-200.
4) Where does the intercooler fit in to the plumbing scheme?
Thanks, Jason
|
1. as long as it's the normal rotation model it should be fine. They have some like the older Vettes where the blower faces the engine and it spins backwards, which would not work in the normal mounted systems. I recommend before you buy any used Procharger to get the serial number off of it and call Procharger to see if it's had any issues, blown up, warranted, etc. All the mounting brackets and piping would probably have to be re-done. If you have the ability to make them that's a way to go, but if you're planning on buying them from Procharger I'd recommend getting a price first, because it's almost always cheaper to buy the complete kit new than it is to buy a used blower and all new brackets, spacers, pulleys, etc. Procharger charges a lot to buy the stuff separately.
2. Should be some diagrams on the Procharger site.
3. Intercoolers are universal for the most part, although some are specifically sized and shaped to fit particular cars. You'll need to determine where you can fit one (if air to air it needs to be in front of the radiator). You have to watch sizing because if you get one that's too small or restrictive you can actually lose power by running it. Gotta watch the cheap Ebay ones, many are not efficient. Another to watch are the used Diesel units, again in many cases they can't flow well enough and in many cases the guys lost power. A lot of the Procharger guys don't run an intercooler and use water/alcohol injection instead. I've done that and it works great, plus with a blow through carb you get some additional air temp reduction. I prefer an intercooler but sometimes there's no room and/or no budget to get a proper one in.
4. An intercooler goes between the blower and the carb in your case.
Additionally, carb and carb hat make a huge difference in the power and driveability of the car. I had great luck with Scott at
http://www.sd-concepts.com/pages/cfHome.cfm for my carbs. His were spot on out of the box, and worlds ahead of my own carbs modded as per Procharger.
Jody