Quote:
Originally Posted by GregWeld
The Koul Tool is really only for people that don't have a nice way to cut this crappy hose (I personally am so 'over it' - this look is what I mean).... and you're right - it (Koul tool) does make it far easier if you can't get a nice cut on the end of your braided stuff. But the key is really just to have the vice jaws to hold the fitting --- and a nice clean cut... then you can save the cost of the extra "not really required" tool. I use the vice jaws for lots of other stuff... and the cutters etc can be used on other things as well... the Koul Tool is a one trick pony.
A BIG PS to the original poster.... IF you're using braided rubber hose for FUEL LINE ---- DON'T. If you have to go flexible -- use the teflon lined (ptfe) braided hose and then you'll only need one extra tool... the hand tool that installs the ferrel and spreads the braid out AFTER you install the sleeve. The PTFE hose will stand up to todays fuels and is also great for high pressure stuff like P/S etc. If you use rubber hose -- you're garage will forever stink like gasoline. Then you're wife gets pissy about your "stinky hot rod" -- and then she goes out and shops all day - thus reducing your tool account! Don't let this happen to you!
PPSS: The PTFE stuff is an extra little nasty hose to install a fitting on! If you cut this crappola with a cutoff tool -- it melts the PTFE -- then you can't get the fitting to go down into the liner... it's super snug fit! Any 'defects' or cuts in the end of the PTFE and you're "hosed" (pun intended). This is where that handy dandy XRP saw blade comes into play - cause it's super sharp and doesn't get hot and melt the liner.... JUST FYI is all.
|
Greg, what brand teflon hoses and fittings do you use and who do you recommend purchasing them through?
thanks