Quote:
Originally Posted by 67ragtp
Blake,
Perhaps I missed it somewhere, I went to your web site, and still can't figure out how the torque arm brackets attaches to a 12 bolt housing. I have a 54 inch flange to flange moser 12 bolt with dse leaf perches. Will housings(custom lengths)with all brackets welded on be available through speed tech? How are you setting this up? Any issues with the upper bracket fitting in the area of the mini tub frame cut? can my housing be converted?
Thanks Rich
|
The 12 bolt has a rear mount that sandwhiches between the rear cover and the housing, on the front there is a billet aluminum clamp that mounts arroiund the pinion casting. Currently we are only able to offer 9" housing that are built by Strange Engineering that include the brackets welded on prior to finishing the housing width. the problem is that strange only had a 12 bolt with the 3rd gen camaro center section so it won't work with our mount. But a 9" is actually a better choice in that the pinion is shorter and lower to allow more clearance between the driveshaft and tunnel as well as the safer housing retained bearings. we ALWAYS use 9" ends on all the rears we build for the safety factor.