Thread: Speedtech A-Body Suspension Questions:
View Single Post
  #3  
Old 12-17-2010, 04:37 PM
BANKO's Avatar
BANKO BANKO is offline
Senior Member
  
Join Date: Jan 2006
Location: Palo Alto, CA
Posts: 230
Thanks: 0
Thanked 0 Times in 0 Posts
Default Thanks!
Blake, thanks so much for your quick response!

For Question 2, I'm ultimately trying to determine how low I can make the car using your spindles and A-arms for a 20" wheel running a 285/30, without reducing overall suspension travel / increasing the spring rate to a point where it is not street worthy. That tire/wheel size would be about 13.4" ground to center of the wheel. So I wasn't sure what that would make the frame rail to ground measurement.

I was hoping to get the frame to be close to 4" off the ground without modifying the floorpan. I plan on running custom inner fenders or no fenders in the front and a custom 3 link and mini-tubs in the rear.

Thanks, Josh
Reply With Quote