TKO Swap
Hey Lutsy, i just did the TKO / TH400 swap myself. I found that the higher you can get the car the easier to perform the install.
Quick tip... leave the clutch/pressure plate off for mock assembly which you will (should) do to measure, measure (yes measure twice) to mark where your shifter hole will go.
Once the mark was made, I used a new factory lower boot and stock 69 Camaro boot retaining ring to trace the actual location of the hole.
I wanted the car to look as if it came from the factory as a 4 speed.
One more thing... I was able to save on a driveshaft by purchasing a new Spicer Yoke and a used Dynotech driveshaft on ebay. My drive shaft was 46" center of u-joint to center of u-joint. Total cost with new 1350 U-joints was under $125. Good luck!
Marco
__________________
Semper Fi 
|