This is a great thread. Especially for me as I am also trying to learn with the new Tig welder. I have been reading and practicing. Things are going better. I'm a visual person. Here is the result of the best I have done so far. I am far from happy, but mind you I've only burned about 4 filler rods with the TIG so far.
I spent a lot of time fitting the panel I made. It was good, but the second one is better. As usual. I am getting ready to start welding the second one. I have it tacked in. Look along the bottom. I was trying to keep everything fitting as I went using a hammer and dolly. I didn't make a weld longer than 1/2" at a time before cooling. I was also hammering the welds as I went to try and keep the panel from shrinking in. When I was done and started the grinding/sanding I realized the panel I added along the bottom was slightly proud. You can see this in the photo. Any suggestions as to how to work this out? A small amount of filler will cover as it is only about 5-10 thou. proud, but I would like to make it better. The same thing happened with the 2 plug weld spots you can see.
This brings me to my next question. What happens when you are butt welding sheet metal and you can't get to the back side to hammer the welds and work the joint? No matter how slow I go and how small the welds are, I almost always end up with the weld bead/HAZ low. Do you use a stud gun or something to raise that area? I will be getting to these types of welds very soon. That's enough for now. Any comments/advice good and bad will be greatly appreciated.
I don't mind others learning from my mistakes!
