ta219,sorry didn't take much detail pics of process but i will say its not to difficult if welding skills are good.there are much hard areas to manage,but since your'e welding two flanges together not a bad place to improve ones skills.still have to take your time & move from side to side.i used about 6 clamps per side which drew the seam extremely tight.almost too thight,trunk lid gap almost to small at the very rear -1/8 but will be fine.my body man was impressed with my welds & gaps(1/8 to 3/16) not bad for my first build,it just takes time, patience.when i got tired or frustated i'd do best to go do something else or take a break.believe me i did a few things more than once .sorry i rattling on,but if have any other ? i'd be more than happy to share or try to help.jerry
|