These are the brackets I made to fit the lower radiator mount cushions on the stock SRT8 Charger radiator that is being used. They bolt to the radiator support. The a/c condensor from the Charger will be mounted on the front of the radiator support.
the reworked torsion bar crossmember is made out of 1/8" steel on all 4 sides & fully welded. The torsion bars are not being used of course.
With one 2 gallon pail of Lizard Skin sound deadener, I was able to spray the entire top side of the floor pan, rear wheel wells & firewall, inside both doors and both 1/4 panels as well as the bottom of the floor pan between the sub-frame rails from the fire wall/floor pan seam to just in front of the rear axle and the area above the fuel tank.
next is a coat of Lizard Skin heat insulator