For those wanting to save LOTS of money but have the time, you can do your own harness. This is what I have done a couple times now.
Buy a low mile 99-04 Cable TB truck harness for $50
Buy a pack of 50 each of 18 and 20ga pcm terminals from Mouser
Buy a crimper for MAC tools for $20
Use Lt1swap.com for fuse block details and wiring diagrams $20
Cut all the pcm wires off and seperate all the individual sensor circuits
Route the wires how you like and terminate at the pcm
Cover with flexbraid from Cabletiesandmore $20
The truck wires are plenty long to route the pcm away from the engine and you end up with about $120 in it.
__________________
Nate
-----------
71 Nova. "The Green Machine" April 11' PHR
|