thanks! also i'm taking ideas from your sunoco camaro
got some sheet metal and got to work. started with a battery box for the battery mount. levels the battery in the trunk instead of it sitting crooked.
laid out some measurements
then i cut on the lines and bent the sides up
and TIG welded it all together
then traced a cut line and cut it out
test fit to trace a cut line for the correct height
welded and smoothed
then made up some fill panels since i removed my package tray. this was also my first attempt with a bead roller, came out pretty good for a newb.
then tacked them into place after some primer/sealer
hopefully tomorrow i'll be able to get the fill panel done for the rear suspension and the trans tunnel mocked up.