been working on this some over the last few days. since i had to cut out a chunk or the floor to mount the rear suspension i needed to replace it now that the suspension is done.
the fill panel mocked up for the last time to check fitment.
from the trunk side. i left the ends open because i need to notch the floor for the exhaust. can't do that until the fuel cell gets here.
tack welded in
half welded, ground down and sanded
the other side fully welded and the 3rd link cover mocked into place. just need to trim a few things and start tack welding it in and then building the a box for the ends.
