[BTTBSS]

Pulled the transmission out of my Impala SS last Saturday. The clutch release
line was a real PIA. The fitting on the MC was/is stuck and almost impossible
to get a wrench on. The fitting on the Throw-out bearing is solid. Wound up
twisting the flex line into a pretzel.

I called Keisler but could not get tech support and no return call so far. What
is needed is a connection that will turn on a hard line at the bearing. There is
room to get a crows foot wrench in there and turn if the fitting were similar
to a brake line. Has anyone tried building a custom line?

Other than the clutch line, the tranny came out with little fuss. I did call
Liberty to see about their shifter upgrades but they quoted $700.00 if I
sent them the transmission. Ouch.